Explainer · 2 min 58 s
ASTM A312 vs A269 vs A213: which specification fits?
ASTM A312, A269 and A213 all cover 316L, but only one describes your line item: pressure piping, general-service tubing or an exchanger tube.
- Format
- Explainer
- Published
- Duration
- 2 min 58 sec
- Language
- English
About this video
This explainer is educational. It explains the published limits and the order fields for the topic; confirm the grade, standard, size, condition, inspection and documents with Junda for each order.
Chapters
Each chapter opens the video at that point on YouTube.
- 0:00
ASTM A312 vs A269 vs A213: which specification fits your 316L
ASTM A312, A269 and A213 all cover 316L, but only one describes your item.
- 0:10
ASTM A312 vs A269 vs A213: pipe, tubing or exchanger tube
A312 is pipe: seamless or welded, for pressure piping, ordered by nominal pipe size and schedule. A269 is tubing for general service: instrument and sample lines, held to tight outside diameter and wall tolerances. A213 is the exchanger tube: seamless, for boiler, superheater and heat-exchanger service. In a shell-and-tube exchanger, A213 tubes pass through a tube sheet, and each is rolled into its hole. That joint is why an exchanger needs a tube, not a pipe. So the drawing that rules the order is the exchanger drawing.
- 0:50
How A312, A269 and A213 each size the same 316L pipe
Take one 316L end. The steel does not change. The order text does. A312 names a pipe size and a schedule. A269 names an outside diameter and wall. A213 follows the exchanger drawing, on a minimum wall.
- 1:09
A1016 vs A999: the general requirements behind the three documents
Now the part most orders leave out. Each of those documents sits on a second document. A269 and A213 both point to A1016 for general requirements. A312 points to A999 instead. Specific clauses win over general ones, and your purchase order wins over both.
- 1:33
Seamless tube and the tests agreed before the heat is melted
The tests start before the tube exists. A213 is seamless; A312 also allows welded pipe. Junda's route is published: seven rolling mills, seven drawing machines, two heat treatment lines, six pickling systems. So the order names the process. The mill should not have to guess it. The tests are the other half of the document. A supplementary requirement is not added after the steel is made. An A262 practice E corrosion test, transverse tension, a radiograph: agreed before the mill melts the heat. A test added afterwards cannot create the coupons it needs.
- 2:13
What a 316L purchase order must name to pass inspection
One field decides acceptance, and it is easy to leave out: the wall basis. Minimum wall means no reading below the limit. Average wall means the readings average to it. Same tube, same nominal wall, different acceptance. If the drawing governs, say so, and make the quotation repeat the basis. So the line item carries the form, the standard and its edition, the process, the dimensions and the wall basis. And the test records: a 3.1 mill certificate with the order, as agreed. A certificate that says conforms to ASTM names nothing. The document, the edition and the results do. Send the form, the standard and the wall basis, and we confirm the 316L against your specification.
Specify the pipe or tube for your project
Send the grade, standard, OD × wall × length, wall basis, quantity, inspection and documents with your enquiry.
