Skip to main content

Explainer · 3 min 9 s

Stainless steel pipe enquiry: 8 fields a mill needs

Eight fields turn a project datasheet into one stainless steel pipe line a mill can quote: standard and edition, wall basis, inspection scope and quantity.

Format
Explainer
Published
Duration
3 min 9 sec
Language
English
Full explainer series: Junda Explainers

About this video

This explainer is educational. It follows the published technical enquiry checklist: the eight fields a mill needs, the A312 and A1016 line item printed in the article, the mass formula from the published weight calculator, and the checks to make before comparing two quotations.

Chapters

Each chapter opens the video at that point on YouTube.

  1. 0:00

    Stainless steel pipe enquiry: 8 fields a mill needs

    A stainless steel pipe enquiry is a translation job. Project datasheets go in. A purchase specification has to come out. Two mills can quote the same pipe and hand back two different products.

  2. 0:12

    What a stainless steel pipe enquiry has to state

    Eight fields make an enquiry a mill can quote without asking anything back. Product and material. Standard and edition. Dimensions with a wall basis. Quantity, condition and inspection. Delivery, and whether alternatives may be proposed.

  3. 0:28

    Which standard and edition the enquiry names

    The standard line is where most enquiries stop being comparable. A312 is the pipe specification: the grade, the manufacture and the tests. A1016 or A999 carries the dimensional and testing baseline. On a code job, the ASME designation comes with it: SA-312.

  4. 0:51

    NPS, outside diameter, wall and the wall basis

    Dimensions are two numbers and a basis. NPS four is 114.3 millimetres of outside diameter. Schedule 40S puts 6.02 millimetres of wall on it, so the bore is 102.26. One word decides what arrives: the wall basis. Average wall: thin places paid for by thick ones. Minimum wall makes the nominal number the thinnest point the order accepts. Same nominal size, and a heavier pipe.

  5. 1:20

    Heat treatment, surface and the inspection scope

    Condition names the heat treatment, the surface and the end finish. The published example is solution annealed and pickled, with plain ends square cut and deburred. Heat treatment leaves an oxide scale on the surface. Pickling removes it, and the condition line has to say so. Inspection is a scope, not a word. Name the method, the coverage, the acceptance criteria and the documents. The published line item asks for 100 % eddy current to E426 and 100 % hydrostatic. Junda publishes UT, ET and hydrostatic testing in house, and confirms the scope in the quotation.

  6. 2:00

    The purchase line, the weight basis and comparing quotations

    Quantity needs one basis, because pieces, metres and tonnes are three answers. The two numbers give the weight: pi times wall times outside diameter minus wall, times density over one thousand. At NPS four in 40S, TP316L is 16.38 kilograms a metre. Six metres is 98.3 kilograms a piece, and 120 pieces is 11.79 tonnes. Written out, the enquiry becomes one purchase line. Grade with its UNS number. Standard with its edition. The size with its millimetres. Then the wall with its basis, the length, the tests and the documents. That is a line a mill can quote without asking three questions. Two quotations on the same line still may not be comparable. Check that every proposed deviation is written down. Check that the test scope matches what the enquiry asked for. Then compare the commercial terms: delivery, packing and the INCOTERMS 2020 line. Send the eight fields, and we confirm the line against them.

Specify the pipe or tube for your project

Send the grade, standard, OD × wall × length, wall basis, quantity, inspection and documents with your enquiry.