Explainer · 3 min 13 s
Super austenitic vs super duplex: 254SMO, 904L or 2507?
Super austenitic vs super duplex is not a corrosion score: 254SMO and 2507 reach almost the same pitting number, and the structure decides the rest.
- Format
- Explainer
- Published
- Duration
- 3 min 13 sec
- Language
- English
About this video
This explainer is educational. It explains the published limits and the order fields for the topic; confirm the grade, standard, size, condition, inspection and documents with Junda for each order.
Chapters
Each chapter opens the video at that point on YouTube.
- 0:00
Super austenitic vs super duplex: what the structure changes
Super austenitic, super duplex: two families, and on the pitting screen they land in the same place. So the screen cannot choose the pipe. The structure can, and it sets what the mill has to prove.
- 0:12
Super austenitic vs super duplex: the pitting number they share
254SMO is one phase: a face-centred cubic austenite, annealed at eleven fifty to twelve hundred. 2507 is two phases: austenite and ferrite, side by side in the same steel. Same screen, one point apart: forty-four against forty-three. The structure is what differs, and it is what the workshop has to protect.
- 0:37
Yield strength: 254SMO against 2507 super duplex
The published minimum yield is the cleanest number between them. 254SMO, three hundred megapascals. 2507, five hundred and fifty. On the same wall, that is one point eight times the load before the steel yields.
- 0:55
Solution annealing and the phases that form at 600 to 1000 °C
Both families leave the mill solution annealed. 904L is annealed at eleven hundred to eleven fifty degrees. 254SMO at eleven fifty to twelve hundred. 2507 is supplied annealed, and cannot be hardened by heat treatment. The anneal is not a formality. It is the condition the certificate is quoting. Here is what the grade name hides. At six hundred to one thousand degrees, intermetallic phases form on these boundaries. 254SMO is published as passing the intergranular test after an hour in that range. 2507 is the one with a balance to lose. A weld procedure outside its window moves the ferrite and austenite apart. That is why the procedure belongs to the grade choice, not to the workshop alone.
- 1:48
How to choose 904L, 254SMO or 2507 in a pipe enquiry
So which one? Start from the duty, not the alloy name. Seawater with crevices and bleaching lines point to 254SMO. Strength, offshore and desalination point to 2507. Reducing acids point to 904L, and that duty needs its own review. None of this changes the outside diameter. The size comes from the line and the design code. What changes is the grade, the UNS number and the standard on the drawing. And the condition: solution annealed, with the balance proved. The certificate is where the condition becomes a claim. Junda issues an EN 10204 3.1 mill test certificate as agreed, with 3.2 third-party inspection when the order names it. So the grade, the UNS, the standard and the condition have to agree on one sheet. Then write it down, in five fields. Grade and UNS designation, on the drawing. The standard: A312, A213, A269 or A376 for the austenitics; A789 or A790 for 2507. Size and wall, from the line and the design code. Condition and certificate: solution annealed, 3.1 as agreed. Send the duty, the grade and the size, and we confirm the pipe against your specification.
Specify the pipe or tube for your project
Send the grade, standard, OD × wall × length, wall basis, quantity, inspection and documents with your enquiry.
