Skip to main content

Short · 53 s

UT, ET and Hydrostatic Testing: Three Questions #shorts

A pipe can pass one inspection and still fail the next. UT, ET and hydrostatic testing each answer a different question: the wall volume, the surface, and…

Format
Short
Published
Duration
53 sec
Language
English
Full explainer series: Junda Explainers

About this video

This explainer is educational. It explains the published limits and the order fields for the topic; confirm the grade, standard, size, condition, inspection and documents with Junda for each order.

Chapters

Each chapter opens the video at that point on YouTube.

  1. 0:00

    A pipe can pass one inspection and still fail the next.

    UT, ET and hydrostatic testing each answer a different question. Here is what each test can see. An eddy current coil never touches the pipe. Its alternating field drives currents in the surface, and a defect changes the signal.

  2. 0:17

    So the method reads the surface and a thin layer below it, not the middle of the wall.

    Now the pressure test. Water fills the bore. The pump holds it, and the wall carries the load. A through-wall defect shows here as a leak.

  3. 0:30

    Detection looks for a defect.

    This test proves the pipe holds. Junda publishes one fully automated UT and ET system. It scans the length for internal and surface defects. The published testing centre lists five intermediate UT inspectors. The full explainer shows what each test proves, and what the order has to name.

Specify the pipe or tube for your project

Send the grade, standard, OD × wall × length, wall basis, quantity, inspection and documents with your enquiry.